OPTICA ™ 300 SHOWER MIXER/TRANSFER V AL VE INST ALLA TION INSTRUCTIONS I N S T A L L E R : L E A VE T H I S I N S T R U C T I O N M A N U A L F O R O W N E R ' S / U S E R ' S R E F E R E N C E W ARNING: This system/device must be set by the installer to ensure safe, maximum temperature.

INST ALLA TION INSTRUCTIONS W ARNING: Failure to follow these instructions could prevent the mixer/transfer valve from functioning properly . 1. Shut OFF water supplies. 2. Install the body (1) so the surface of the fi nished wall is fl ush with the front of the plasterguard (2).

9. Flush your system prior to installing the shower head. Place handle on valve stem and turn handle to full mix position. Turn ON water supplies, check for leaks and let lines fl ush for one minute without moving faucet handle. Divert water to shower head and fl ush for 30 seconds.

Faucet leaks from bath spout/showerhead – SHUT OFF W A TER SUPPLIES Replace seats and springs – Repair Kit RP4993. Check conditions of lower o-rings and replace if necessary .

1st Position 2nd Position 50 70 50 70 70 70 40 85 3rd Position 61 79 67 83 74 89 70 101 4th Position 68 83 75 90 84 97 84 1 10 5th Position 74 87 85 96 91 104 95 1 17 6th Position 79 90 91 101 99 1 10.

Jacuzzi Whirlpool Bath 14801 Quorum Dr ., Suite 400, Dallas, TX 75254 Service Support: Call 1-800-288-4002 ©1995 Jacuzzi Whirlpool Bath G570000 D 12/06 Printed in the U.